Kanguru U2D - Manual (Page 24)

22
3.7 Erase
The ERASE function will delete all data on a USB drive. This function doesn’t require a Source drive so
all USB ports can be used during the erase process.
Caution! Make sure that you have removed any Source USB drives or Storage Centers before performing
the erase function.
To erase your USB drives:
1. From the Main menu, tap the ‘SET’ button to navigate to the ERASE function.
2. Connect your USB drives to any available USB ports. When your USB drives have been connected
and initialized, the screen will display the following:
Number of connected devices
ERASE 11/11
READY TO GO . . .
Number of available USB ports
3. Tap the ‘RUN’ button to begin the erase process. The following screen will be displayed during
the erase function.
ERASE 11/11
22MB/s 55% 2.31G
Percentage completed
Total data erased Data erase rate
4. Once the erase process has completed, the following screen will be displayed:
Number of erased devices
Number of devices
failed
ERASE 11/11
REMOVE 10PSs 0 FLs
5. Remove all connected USB drives to return to the Main menu.
Erase