Kanguru 5HD Tower Duplicator - Manual (Page 22)

22
4.8 DCo Check
The Device Configuration Overlay (DCO) is a partition on the hard drive that is not normally visible
to an operating system. If the Master drive contains a DCO partition, then the DCO may not be
accessible to the duplicator unless this option is enabled.
Press the ENT button to change this option.
• [ ٭ ] – DCO Check is enabled (default). When DCO CHECK is enabled the duplicator will
recognize the Device Configuration Overlay area.
• [ ] – DCO Check is disabled. The system will not check for DCO partitions. Drives that
contain a DCO partition may not duplicate successfully.
4.9 button Sound
The BTN. SOUND option allows you to enable or disable the audible tone that accompanies every
button press.
Press the ENT button to change this option.
• [ ٭ ] – Button sounds are enabled (default). Button presses and system notifications will be
accompanied by a short, audible tone.
• [ ] – Button sounds are disabled. No audible tones will sound.
4.10 Show EXE Time
The SHOW EXE TIME option allows you to enable or disable whether the total execution time for
an operation is displayed on the LCD screen. The total execution time will be displayed after an
operation has completed.
Press the ENT button to change this option.
• [ ] – Disabled (default). The total execution time is not displayed.
• [ ٭ ] – Enabled. The total execution time is displayed.
DCO Check / Button Sound / Show EXE Time