Kanguru 5HD Tower Duplicator - Manual (Page 16)

16
2.4 Duplication
IMPorTaNT! Insert all Master and Target hard drives before you execute a Copy operation.
To execute the duplication of a Master hard drive:
1. From the Main menu, press the UP or DoWN button to navigate to the desired copy mode. For
more information on the different copy modes see section 2.2 Duplication Modes on page 13.
[BRIEF ] COPY
0 PASS 0 FAIL
Copy Mode
Copy and/or Compare enabled
Total successful copies Total failed copies
2. Once you have selected the desired copy mode, press the ENT button to execute the copy
function. Before the duplication process begins the system will check for any connected drives.
3. Once all drives have been detected and initialized, the duplication process begins. During the
duplication process the LCD screen will display the following information:
[BRIEF ]COPY (T:5)
51M 21.32% 130G
Copy mode
Transfer rate
Copy or Compare in progress
% completed
Number of targets
Data remaining
WarNING! Do not remove any drives while duplication is in process. If you want to stop the
duplication process, press the ESC button to cancel at any time.
4. Once the copy process has completed the Kanguru Clone will list each Target drive location
with either a “V” or “X”.
○ V - Appears next to any drive verified to have completed duplication successfully.
○ X - Appears if a drive failed duplication for any reason. When a drive fails duplication, an
error code can be generated. For a list of common error codes and their meanings, please see
chapter 5. Error Code List on page 27.
○ KCLONE-5HD-TWR press the UP button to view error codes
○ KCLONE-11HD-TWR press and hold the ENT button to view error codes
[BRIEF ]COPY
1:X 2:V 3:V 4:V 5:V
[BRIEF ]COPY
1:K 2:11 3:11 4:11 5:11
5. Press any button to return to the Main menu. The duplicator will automatically keep a running
count of the number of passed and failed duplications until you change copy modes.
[BRIEF ]COPY
4 PASS 1 FAIL
Duplication