Kanguru e-Flash - Manual (Page 8)

8
Caution! Do not touch any of the boards or other components inside the computer without first
grounding yourself by touching the computer’s metal frame or power supply. This discharges any
static electricity that could damage your system. To minimize the risk of static electricity damage,
refrain from handling parts of your computer not used in this installation process.
3. Locate an available SATA port on your computer motherboard. If your computer has an internal
SATA hard drive installed, you can trace the data cable from the hard drive to the SATA ports
on the mother board.
If your motherboard does not have SATA ports, you will have to purchase and install a separate
SATA host controller card in order to connect the Power Over eSATA bracket. If you purchase a
PCI or PCIe SATA host controller card, make sure that it has an internal SATA port.
4. Connect one end of the provided SATA data cable to an available SATA port, and then connect the
other end to the Power Over eSATA bracket. Both ends of the SATA data cable are identical.
Connecting to the motherboard Connecting to the SATA host controller card
Connecting and Using Your Kanguru eFlash