Kanguru e-Flash - Manual (Page 7)

7
2.1.1 Power Over eSATA
The eFlash’s main feature is Power Over eSATA compatibility.
Unlike a standard eSATA connection which only transfers data, the Power Over eSATA connection
transfers both data and power. In order to take advantage of the eFlash’s Power Over eSATA connection,
you must have a Power Over eSATA port. The eFlash comes with a Power Over eSATA bracket that
once installed on your computer, provides you with a Power Over eSATA port.
You can connect the eFlash directly to the Power Over eSATA port or to the Power Over eSATA port
using the provided Power Over eSATA cable.
Note: Standard eSATA cables only transfer data and will not transfer power, even when connected to
a Power Over eSATA port.
2.1.1.1 Installing the Power Over eSATA bracket
The eFlash comes with a Power Over eSATA bracket that once installed on your desktop computer,
will provide a Power Over eSATA port. The bracket will occupy one PCI bay, so you will need to have
an available PCI bay in your computer in order to install the Power Over eSATA bracket.
You may want to print out these instructions for your reference during installation.
1. Make sure your computer is powered down and then unplug the computer’s power cable.
2. Open the computer’s casing, which is usually held on by screws in the back. Locate the following
components:
(A) Power Supply
(B) PCI Slot
(C) SATA Port
1) on host adapter (only necessary if your motherboard does not have SATA ports)
2) on the mother board
Note: The layout of your computer may differ from the images presented in these instructions. They
should be used for reference only. Please refer to your computer’s instruction manual to locate the
components detailed above on your specific system.
A
B
C1
C2
Connecting and Using Your Kanguru eFlash
PC Internal Diagram