Johnson Amplification J-STATION - Manual (Page 35)

Continuous Control (CC)
Continuous Control is a type of MIDI command capable of changing the value of a parameter on any MIDI device in
real time. Every Parameter in the J-Station is assigned an individual CC number.These CC commands make up the
backbone when using the Windows based Editor/Librarian software to control or program the J-Station. Sending value
changes on these CC numbers will change the Parameter setting in real time. Conversely, changing the values on the J-
Station’s front panel will be displayed on the computer Editor/Librarian control panel.The following list identifies each
Parameter’s assigned CC number:
Factory Reset
The Factory Reset procedure is used to restore the J-Station to it’s original Factory settings.This procedure
will erase all user programmed Presets, and Utility settings.
ATTENTION: Performing this function will erase all user-programmed data.All such data will be lost forever!
Be sure you want to erase the memory and start fresh before continuing with this procedure.
The procedure for performing a Factory Reset is as follows:
1. Press the Shift button once.
2. Press the Tuner/Utility button once.
3. Press the Tap-It (>) button until Fr is shown in the Display.
3. Rotate the Data knob clockwise.The Display alternates between Fr and St and the Store button begins
to flash.This is your last chance to change your mind. Rotating the Data counterclockwise or pressing the
Tuner/Utility button will abort the Reset procedure.
4. If you are sure that you want to reset all user settings, press the Store button.
5. Press the Tuner/Utility button again to exit.
Parameters
Compressor
On/Bypass
Threshold
Ratio
Gain
Frequency
Wah/Pitch
On/Bypass
Wah Type
Wah Heel
Wah Toe
Amp Modeling
Model Type
Gain
Treble
Mid
Bass
Level
Cabinet Emulator
Cabinet Type
Noise Gate
On/Bypass
Attack
Threshold Volume
Master Level
Volume Pedal
Digital Output
Level
MIDI CC
CC 1
CC 2
CC 3
CC 4
CC 5
CC 8
CC 9
CC 10
CC 11
CC 34
CC 35
CC 39
CC 38
CC 37
CC 36
CC 66
CC 41
CC 42
CC 43
CC 7
CC 68
CC14
Parameters
Effects
On/Bypass
Type
Level
Speed
Depth
Regeneration
Position
Delay
On/Bypass
Type
Level
Delay Time Course
Delay Time Fine
Delay Feedback
Reverb
On/Bypass
Type
Level
Diffusion
Density
Decay
Assignments
Parameter
Maximum Value
Minimum Value
MIDI CC
CC 44
CC 45
CC 46
CC 47
CC 48
CC 49
CC 50
CC 52
CC 53
CC 54
CC 55
CC 56
CC 57
CC 59
CC 60
CC 61
CC 62
CC 63
CC 65
CC 70
CC 71
CC 72