Johnson Amplification J-STATION - Manual (Page 32)

Section Five - Other Functions
Utilities
The Utility section contains various menus which affect global functions of the J-Station.These menus
include:Assign Mode, Output Mode, Dry Track Enable, Digital Output Level, Global Cabinet Emulator, MIDI
Loop Back, MIDI Channel, MIDI Dump, and Factory Reset. To access the Utility functions, press the Shift
button.The Shift button will light. Press the Tuner/Utility button and the word Util will scroll across the
display indicating that you are in Utility mode.The Display will then alternate between showing the currently
selected Utility menu, and the current status or value for that menu. Once the Utilities have been accessed,
pressing the Effect Type button (<) will select the previous Utility menu, and pressing the Tap-It button (>)
will move forward through the Utility menu selections. Rotating the Data knob will change the value or sta-
tus of the selected Utility. Pressing the Tuner/Utility button will exit the Utility menu and return the J-
Station to the previous mode.
Assign Menu
The Assign Menu allows you to select which J-Station Parameter you would like to assign to the Expression
Pedal on the J8 Foot Controller. In addition to selecting a Parameter to be controlled, you can also set mini-
mum and maximum values the Parameter will reach as you rock the Expression Pedal back and forth.The
procedure for selecting Assign mode, and making an assignment is as follows:
1. Press the Shift button.The button will light
2. Press the Tuner/Utility button.This button will also light.
3. Press the Effect Type (<) button until as (abbreviation for Assign) shows in the display.The Display will
then flash between as and the currently assigned Parameter number.
4. Using the Parameter list below, rotate the Data knob to select the Parameter you wish to assign.
5. Press the Tap-It (>) button once and the Display will alternate between showing pf (an abbreviation for
Pedal Forward) and the currently assigned value the Parameter will reach when the expression Pedal is in
the forward (toe down) position. Rotate the Data knob to select the desired value.
6. Press the Tap-It (>) button again and the Display will alternate between showing pb (an abbreviation for
Pedal Back) and the currently assigned value the Parameter will reach when the expression Pedal is in the
back (toe up) position. Rotate the Data knob to select the desired value.
7. Press the Tuner/Utility button again to exit.
nL = No Link
01 = Master Level
02 = Volume Pedal
03 = Gain
04 = Treble
05 = Mid
06 = Bass
07 = Amp Level 08 = Effect Level
09 = Effect Parameter 1
10 = Effect Parameter 2
11 = Effect Parameter 3
12 = Delay Level
13 = Delay Feedback
14 = Reverb Level