Jetway Computer NF3E - Manual (Page 38)

33
PS2 KB/MS Wakeup
The optional settings: [Disabled]; [Enabled].
Use this item to enable or disable PS2 KB/MS wakeup from S3/S4/S5 state.
*This item will only show when ‘ERP Support’ is set as [Disabled].
USB S3/S4 Wakeup
The optional settings: [Disabled]; [Enabled].
Use this item to enable or disable USB S3/S4 wakeup.
*This item will only show when ‘ERP Support’ is set as [Disabled].
 Super I/O Configuration
Press [Enter] to make settings for the following sub-items:
Super IO Configuration
ERP Function
The optional settings: [Auto]; [Disabled].
This item should be set as [Disabled], if you wish to have all active wake-up
functions.
 Serial Port 1 Configuration
Press [Enter] to make settings for the following items:
Serial Port 1 Configuration
Serial Port
Use this item to enable or disable serial port (COM).
Change Settings
Use this item to select an optimal setting for super IO device.
Transmission Mode Select
The optional settings are: [RS422]; [RS232]; [RS485].
Mode Speed Select
The optional settings are: [RS232/RS422/RS485=250kbps]; [RS232=1Mbps,
RS422/RS485=10Mbps].
Serial Port FIF0 Mode
The optional settings are: [16-Byte FIF0]; [32-Byte FIF0]; [64-Byte FIF0]; [128-Byte