Jetway Computer NF3E - Manual (Page 36)

31
 PCH-FW Configuration
Press [Enter] to view ME information and make settings for ‘Firmware Update
Configuration’.
▶ Firmware Update Configuration
Press [Enter] to make settings for ‘ME FW Image Re-Flash’.
ME FW Image Re-Flash
Use this item to enable or disable ME FW Image Re-Flash function.
The optional settings: [Disabled]; [Enabled].
* In the case that user needs to update ME firmware, user should set ‘ME FW
Image Re-Flash’ as [Enabled], save the settings and exit. The system will turn off
and reboot after 4 seconds. If the user goes to BIOS screen again will find this item
is set again as [Disabled], but user can still re-flash to update firmware next time.

AMT Configuration
Use this item to configure Active Management Technology parameters.
Press [Enter] to make settings for the following sub-items:
Intel AMT
Use this item to enable or disable Intel Active Management Technology BIOS
extension.
The optional settings: [Disabled]; [Enabled].
BIOS Hotkey Pressed
Use this function to enable or disable BIOS Hotkey Press function.
MEBx Selection Screen
Use this function to enable or disable MEBx Selection Screen function.
Hide Un-Configure ME Confirmation
Use this function to enable or disable Hide Un-Configure ME without password
Configuration Prompt function.
MEBx Debug Message Output
Use this function to enable or disable MEBx Debug Message Output function.
Un-Configure ME
Use this function to enable or disable Un-Configure ME without password function.