Ivoclar Vivadent Helioseal v.1 User Manual

Page 2

Step-by-step application procedure
Shake the Helioseal bottle well before use. Open
the bottle only immediately before use to prevent
premature polymerization by light.

1. Thoroughly clean the enamel surface
to be sealed.

2. Isolate the working field, preferably
with a rubber dam.

3. Apply an etching gel, e.g. Email
Preparator blue, and let it react for 30 to
60 sec.

4. Rinse thoroughly.

5. Dry with water- and oil-free air. The
etched enamel should have a mat white
appearance. Avoid contamination of the
etched surface with saliva.

6. Apply Helioseal directly with the
disposable cannula or a brush, and
disperse.

7. Wait for approx. 15 sec. Then cure the
sealant with a suitable polymerization
light (e.g. Astralis) for 20 sec.

8. Check seal and occlusion.

Recommendation
We recommend subsequent fluoride application
(e.g. Fluor Protector) to provide optimum protection
after sealing.

Warning
Avoid contact of unpolymerized material with
skin/mucous membrane or eyes. Unpolymerized
Helioseal may cause slight irritations and, in rare
cases, may lead to a sensitization against met-
hacrylates.

Storage
– Close Helioseal bottle immediately after use.
– Store material at 2–28 °C (36–82 °F).
– Shelf life: see date of expiration.
– Do not use the material after the indicated date

of expiration.

Keep out of the reach of children
For use in dentistry only.

Manufacturer
Ivoclar Vivadent AG.
FL-9494 Schaan

Date information prepared
12/2002

This material has been developed solely for use in dentistry. Proces-
sing should be carried out strictly according to the Instructions for
Use. Liability cannot be accepted for damages resulting from failure
to observe the Instructions or the stipulated area of application. The
user is responsible for testing the material for its suitability and use
for any purpose not explicitly stated in the Instructions. Descriptions
and data constitute no warranty of attributes and are not binding.

30-60 SEC