Ivoclar Vivadent PS Empress CAD Chairside - Manual (Page 20)

20
The IPS Empress CAD restoration is etched using the IPS Ceramic Etching Gel. The IPS Empress CAD restoration is silanized using Monobond Plus.
Adhesive cementation
Preparation of the IPS Empress CAD restoration
To condition it for placement, etch the IPS Empress CAD restoration for 60 seconds using IPS Ceramic Etching Gel and
clean it under running water. Subsequently, silanize the bonding surface of the restoration using Monobond Plus. Observe
the corresponding safety instructions.
The restoration is positioned and excess material is removed. For polymerization, the restoration margin is covered with glycerine gel and the restoration is
polymerized from all sides.
Conditioning the preparation
You may choose between tried-and-tested luting composites from Ivoclar Vivadent for the adhesive cementation. In the
documented case, Variolink II / Syntac were used.
– To condition the preparation for adhesive cementation with Variolink II / Variolink Veneer, Total Etch is used. Total Etch is
an enamel etching (30 seconds of etching) and dentin conditioning material (10–15 seconds of etching).
– To condition the preparation for adhesive cementation with Multilink Automix, Multilink Primer A/B is used.