Dynex DX-LDVD22-10A - Manual (Page 9)

TV components
5
Remote control
6 AUDIO IN jacks Connect the audio output (L and R) from an
AV device to these jacks. For more
information, see “Connecting a VCR” on
page 8.
7 S-VIDEO jack Connect an S-Video device to this jack.
S-Video does not carry an audio signal, so
you will need to connect audio cables from
the device to the AUDIO IN jacks.
8 COMPONENT IN
jacks Connect a component video device to
these jacks. For more information, see
“Connecting a component video device” on
page 9.
9 (Component)
AUDIO IN jacks Connect the audio output (L and R) from a
component device to these jacks. For more
information, see “Connecting a component
video device” on page 9.
10 Headphone jack Plug headphones into this jack.
11 ANT/CABLE IN jack Connect the 75 ohm cable from an antenna
or cable box to this jack.
## Component Description
# Button Description
1 POWER Press to turn on your TV. Press again to put
your TV in Standby mode.
2 INPUT Press to select the input source.
3 CCD Press to turn closed captioning on or off. For
more information, see “Using closed
captioning” on page 20.
4 MTS/SAP Press to select the audio mode. For analog
channels, you can select STEREO, SAP
(secondary audio program), or MONO.
For digital channels, you can select the audio
track (if more than one track is available). For
more information, see “Adjusting the sound”
on page 13.
5 Numbers Press to enter channel numbers or the
parental control password.
6 RECALL Press to go to the last viewed channel.
POWER DVD OPEN/CLOSE
CCD MTS/SAP SLEEP PICTURE
1 2 3
4 5 6
7 8 9
0
MUTE
CH+
CH-
VOL
-
VOL
+
ENTER
MENU INFO
CH.LIST FAVORITE ZOOM
TITLE DISPLAY SETUP SUBTITLE
REV PREV NEXT
PLAY/ENTER
PAUSE MENU STOP
SLOW
ZOOM T.SEARCH
PROGRAM REPEAT A-B
EXIT
RECALL
INPUT
ANGLE
AUDIO
GUIDE
43
34
35
36
37
38
31
32
33
40
42
41
39
10+
DX-LDVD22-10A_09-0042.book Page 5 Monday, March 9, 2009 1:17 PM