Dynex DX-LDVD22-10A - Manual (Page 8)

4
TV components
Removing the stand
To remove the stand from the stand column:
1 Lay your TV face down on a table or bench. Make sure that you
put down a soft cushion or cloth so that your TV is not scratched.
2 Adjust the stand so that the angle between the stand and the TV
is 90°.
3 Remove the two (2) M4 screws that secure your TV to the stand,
then pull the stand off the TV.
Installing a wall-mount bracket
If you want to attach the TV to a wall-mount bracket (not provided), you
should first remove the stand.
To attach your TV to a wall-mount bracket:
Warning: These servicing instructions are for use by qualified service
personnel only. To reduce the risk of hazards, do not perform any
servicing other than that contained in the operating instructions
unless you are qualified to do so.
• Secure the wall-mount bracket to the back of your TV using the
four M4 screws provided with the bracket.
TV components
Front and side panels
Back
# Component Description
1 MENU Press to open the on-screen menu.
2 INPUT Press to select the video input source.
3 VOL+/VOL- Press to increase or decrease the volume.
4 CH+/CH- Press to go to the next or previous channel
in the channel list.
Remove screws
VOL VOL CH CH POWER MENU INPUT + - + -
5
POWER button Press to turn on your TV. Press again to put
your TV in standby mode.
6 Power indicator Lights blue when your TV is turned on.
Lights red when your TV is in standby mode.
Not lit when the power cord is unplugged.
7 Remote sensor Receives signals from the remote control. Do
not block.
## Component Description
1 HDMI jack Connect an HDMI device, such as a cable
box or DVD player, to this jack. An HDMI
cable carries both video and audio, so you
do not need to make an audio connection.
For more information, see “Connecting an
HDMI device” on page 9.
2 PC AUDIO jack Connect the audio output from your
computer to this jack. For more
information, see “Connecting a computer”
on page 9.
3 VGA jack Connect the video output from your
computer to this jack. For more
information, see “Connecting a computer”
on page 9.
4 SERVICE For firmware update only.
5 VIDEO IN jack Connect the video output from an AV
device to this jack. For more information,
see “Connecting a VCR” on page 8.
# Component Description
PC
AU
DIO
IN
COMPONENT
IN
A UD
IO
IN
R
L
VIDE
O
IN
Y
P b
P r
S-
V IDE
O
IN
A U D IO
IN
L
R
A N T/C
A B LEI
N
VGA
IN
HD
MI
SER
VI
CE
DX-LDVD22-10A_09-0042.book Page 4 Monday, March 9, 2009 1:17 PM