Guralp Systems CD1.1 - Manual (Page 18)

CD1.1 Tools for Platinum
3 Typical configurations
Some typical scenarios, with the associated module set-ups,
are shown in the following diagrams.
3.1 Single seismic station
In this scenario, one or more analogue sensors are digitised by
a CMG-DM24, the output from which is fed over a serial or
network link to a CMG-EAM. The data are passed to gdi-base
in the normal way and the gdi2cd11 module combines them
with state-of-health and other meta-data to form CD1.1
subframes. These are passed to the multiplexor, which
assembles them into frames for onward transmission by the
CD1.1 sender.
18 Issue C