Guntermann & Drunck Dynamic-UserCenter 32 Installation - Manual (Page 8)

Installation
6 · G&D Dynamic-UserCenter 32
8. Enter the following data under Global network settings :
9. Click OK to save your changes.
10.Click the Logout icon (see figure on the right) to close the active session
in the web application.
11.Remove the twisted pair cable between computer and device.
12.Use a category 5e (or better) twisted pair cable to connect the configured network
interface(s) Network A or Network B to the network.
Operational
mode:
Select the operational mode of Interface A or Interface B :
 Off: switches off network interface.
 Static: uses static settings.
 DHCP: obtains the settings from a DHCP server.
IP address: Only if the Static operational mode is selected: Enter the
interface IP address.
Netmask: Only if the Static operational mode is selected: Enter the net-
work netmask.
Connection
type:
Select if the network interface and the remote station are to
negotiate the connection type automatically ( Auto ) or if you
want to use a connection type provided in the pull-down
menu.
Operational
mode:
Select the desired operational mode:
 Static: use static settings.
 DHCP: get settings from a DHCP server.
Hostname: Enter the device’s hostname.
Domain: Enter the domain the device is to belong to.
Gateway: Enter the gateway IP address.
DNS Server 1: Enter the DNS server IP address.
DNS Server 2: Enter the IP address of another DNS server (optional).
The following settings are automatically obtained in the DHCP operating
mode. Inputs are not possible.