Guntermann & Drunck Dynamic-UserCenter 32 Installation - Manual (Page 11)

Installation
G&D Dynamic-UserCenter 32 · 9
Step 4: Connecting target modules and matrix
switches
1. Use a category 5e (or better) twisted pair cable to connect each configured CPU -
port with one target module.
2. Use a category 5e (or better) twisted pair cable to connect the configured Cluster
ports of each port group to a free CPU port of the different matrix switches.
ADVICE: To facilitate installation, you can enable the port mode (see page 14).
NOTE: The maximum distance between a user module and a matrix switch can be
140 meters.
ADVICE: The device’s default settings allow you to connect user modules of the
DVI-CON series instead of matrix switches.
You can change this setting under
Direct consoles in the web application.