Guntermann & Drunck Dynamic-UserCenter 32 Installation - Manual (Page 6)

Installation
4 · G&D Dynamic-UserCenter 32
Installation
Step 1: Establishing the power supply
Main Power: Plug one of the supplied power cable in this interface. Connect the
power cable with a power outlet and turn the power button on.
Red. Power: If required, plug one of the supplied power cable in this interface to
establish a redundant power supply. Connect the power cable with a power outlet of
another power circuit and turn the power button on.
NOTE: When choosing a place for the device, please ensure to comply with the
ambient temperature limit (see Technical data on page 16) close to the device. The
ambient temperature limit must not be influenced by other devices.
When installing the devices, make sure to only place a maximum of three devices
directly on top of each other. This provides sufficient circulation of air and mutual
thermal interference can be avoided. After having installed three devices, provide
for a distance of at least 3cm.