Grandstream GXP1100 User Manual - Manual (Page 43)

FIRMWARE VERSION 1.0.8.4 GXP1100/GXP1105 USER MANUAL Page 41 of 53
server will act as an intermediary to route the packets to the destination.
Layer 3 QoS
Defines the Layer 3 QoS parameter. This value is used for IP Precedence,
Diff-Serv or MPLS. The default value is 12.
Layer 2 QoS
802.1Q/VLAN Tag
Assigns the VLAN Tag of the Layer 2 QoS packets. The default value is 0.
Layer 2 QoS 802.1p
Priority Value
Assigns the priority value of the Layer2 QoS packets. The default value is 0.
PC Port Mode
Configures the PC port mode. When set to "Mirrored", the traffic in the LAN
port will go through PC port as well and packets can be captured by
connecting a PC to the PC port. The default setting is "Enable".
Enabled LLDP Control the LLDP service.
MAINTENANCE PAGE DEFINITIONS
Maintenance -> Web Access
End User Password
Allows the administrator to set the password for user-level web GUI access.
This field is case sensitive with a maximum length of 30 characters.
Confirm Password Confirms the end user password field to be the same as above.
Admin Password
Allows users to change the admin password. The password field is purposely
hidden for security purpose. This field is case sensitive with a maximum length
of 30 characters.
Confirm Password Confirms the admin password field to be the same as above.
Maintenance -> Upgrade and Provisioning
Firmware Upgrade and
Provisioning
Specifies how firmware upgrading and provisioning request to be sent: Always
Check for New Firmware, Check New Firmware only when F/W pre/suffix
changes, Always Skip the Firmware Check.
XML Config File
Password
The password for encrypting the XML configuration file using OpenSSL. This
is required for the phone to decrypt the encrypted XML configuration file.
HTTP/HTTPS User
Name
The user name for the HTTP/HTTPS server.
HTTP/HTTPS Password The password for the HTTP/HTTPS server.
Upgrade Via Allows users to choose the firmware upgrade method: TFTP, HTTP or HTTPS.
Firmware Server Path
Defines the server path for the firmware server. It could be different from the
configuration server for provisioning.
Config Server Path
Defines the server path for provisioning. It could be different from the firmware
server for upgrading.
Firmware File Prefix This field enables user to store different versions of firmware files in one single