Grandstream GXP1100 User Manual - Manual (Page 41)

FIRMWARE VERSION 1.0.8.4 GXP1100/GXP1105 USER MANUAL Page 39 of 53
it will ring ON ms and a pause of OFF ms and then repeat the pattern. Up
to three cadences are supported.
Call Waiting Tone Gain
Configures the call waiting tone gain to adjust call waiting tone volume.
The default setting is "Low".
Settings -> Audio Control
Handset TX gain
Configures the transmission gain of the handset. The default value is 0
dB.
Settings -> Programmable Keys
Multi Purpose Keys X
Assigns a function to the corresponding Multi Purpose Key. The key
mode options are:

Speed Dial
Enter the Speed Dial number in Value field to be dialed.

Dial DTMF
Enter a series of DTMF digits in the Value field to be dialed during
the call. "Enable MPK Sending DTMF" has to be set to "Yes" first.

Voice Mail
Enter the Voice Mail access number in the Value field.

Call Return
The last answered calls can be dialed out by using Call Return. The
Value field should be left blank.

Transfer
Enter the number in the value field to be transferred (blind transfer)
during the call.

Intercom
Enter the extension number in the value field to do the intercom.

3-way Conference
To establish 3-way conference.
NETWORK PAGE DEFINITIONS
Network -> Basic Settings
Internet Protocol Selects Prefer IPv4 or Prefer IPv6.
IPv4 Address Type
Allows users to configure the appropriate network settings on the phone to
obtain IPv4 address. Users could select "DHCP", "Static IP" or "PPPoE". By
default, it is set to "DHCP".
DHCP Host name
(Option 12)
Specifies the name of the client. This field is optional but may be required by
some Internet Service Providers.
DHCP Vendor Class ID Used by clients and servers to exchange vendor class ID.