beautypg.com

Grandstream GXP1100 User Manual User Manual

Page 35

background image

FIRMWARE VERSION 1.0.8.4

GXP1100/GXP1105 USER MANUAL

Page 33 of 53

Check Domain

Certificates

Choose whether the domain certificates will be checked or not when TLS/TCP

is used for SIP Transport. The default setting is "No".

Validate Incoming

Messages

Choose whether the incoming messages will be validated or not. The default

setting is "No".

Check SIP User ID for

incoming INVITE

If set to "Yes", SIP User ID will be checked in the Request URI of the incoming

INVITE. If it doesn't match the phone's SIP User ID, the call will be rejected.

The default setting is "No".

Accept Incoming SIP

from Proxy Only

When set to "Yes", the SIP address of the Request URL in the incoming SIP

message will be checked. If it doesn't match the SIP server address of the

account, the call will be rejected. The default setting is "No".

Authenticate Incoming

INVITE

If set to "Yes", the phone will challenge the incoming INVITE for authentication

with SIP 401 Unauthorized response. The default setting is "No".

Account 1 -> Audio Settings

Send DTMF

Specifies the mechanism to transmit DTMF digits. There are 3 supported

modes: in audio which means DTMF is combined in the audio signal (not very

reliable with low-bit-rate codecs), via RTP (RFC2833), or via SIP INFO.

DTMF Payload Type

Configures the payload type for DTMF using RFC2833. The default value is

101.

Preferred Vocoder

7 different vocoder types are supported on the phone, including G.711 U-law

(PCMU), G.711 A-law (PCMA), G.723.1, G.729A/B, G.722 (wide band), iLBC

and G72-32. Users can configure vocoders in a preference list that is included

with the same preference order in SDP message.

Use First Matching

Vocoder in 200OK SDP

When set to "Yes", the device will use the first matching vocoder in the

received 200OK SDP as the codec. The default setting is "No".

SRTP Mode

Enables the SRTP mode based on your selection. The default setting is

"Disabled".

Crypto Life Time

Choose whether to include the lifetime parameter in SRTP crypto offer.

Symmetric RTP

Defines whether symmetric RTP is supported or not. The default setting is

"No".

Silence Suppression

Controls the silence suppression/VAD feature of the audio codec G.723 and

G.729. If set to "Yes", when silence is detected, a small quantity of VAD

packets (instead of audio packets) will be sent during the period of no talking.

If set to "No", this feature is disabled. The default setting is "No".

Voice Frames Per TX

Configures the number of voice frames transmitted per packet. When

configuring this, it should be noted that the "ptime" value for the SDP will

change with different configurations here. This value is related to the codec

used and the actual frames transmitted during the in payload call. For end

This manual is related to the following products: