GAI-Tronics 12514-007, 12514-008, 12514-009 6', 15', 25' Coil Cord, 6C and Bushing Kit - Manual (Page 5)

Pub. 42003-035B
M ODELS 12514-007, 12514-008, AND 12514-009 PVC C OIL C ORD R EPLACEMENT K IT Page: 5 of 6
\\s_eng\gtcproddocs\standard ioms - current release\42003 kit manuals\42003-035b.doc
Models 711-002, 7115-002, 611C, and 6115
Removal of old cord
1. Remove the two mounting screws from the mounting bracket. Remove the subset from the mounting
bracket.
2. Remove the four screws on the left side of the unit.
3. Locate the PC board. On the side closest to you, you will see the six handset wires. Unplug all six of
the wires.
4. Use a Heyco® bushing tool to remove the bushing securing the cord to the subset. Pull the cord
through the hole and remove.
5. At the handset end, unscrew the transmitter cap, lift out the transmitter and disconnect the wires.
6. Unscrew the receiver cap, lift out the receiver and disconnect the red and green wires from the
receiver.
7. FOR HANDSETS WITH PRESSBAR ONLY: Loosen the two screws securing the pressbar. Lift off
the metal retainer, plastic pressbar, curved spring and plunger. Lift out the rectangular plastic cup and
disconnect the blue and yellow wires.
8. Pull the old cord out of the handset and discard.
Installation of new cord
1. Feed the red and green wires through the transmitter end of the handset, through the center of the
handset to the receiver end. Secure the wires to the receiver.
2. Place the receiver in the cup. Tighten the receiver cap.
3. FOR HANDSETS WITH PRESSBAR ONLY: Feed the yellow and blue wires through the handset
to the pressbar area. Secure the wires to the terminals in the plastic cup. Place the plastic cup in the
handset. Refer to Figure 1. Place the copper piece with the rubber center in first, with the solid
rubber side up. Install the curved spring. Place the plastic pressbar in with the GTC logo side up.
Place the metal bracket on top. Tighten the screws.
4. Attach the black and white wires to the transmitter terminals.
5. Place the transmitter in the transmitter cup, making sure that the cord guide snaps firmly onto the cord
to secure it. Screw on the transmitter cap.
6. Feed the other end of the cord through from the front panel of the phone and use a Heyco® tool or
needlenose pliers to secure the bushing on the front of the subset.
7. Reconnect the wires to the PC board according to the labels on the board.
8. Replace the four screws to reassemble the unit.
9. Use the two mounting screws to secure the subset to the mounting bracket.