GAI-Tronics 12514-007, 12514-008, 12514-009 6', 15', 25' Coil Cord, 6C and Bushing Kit - Manual (Page 4)

Pub. 42003-035B
M ODELS 12514-007, 12514-008, AND 12514-009 PVC C OIL C ORD R EPLACEMENT K IT Page: 4 of 6
\\s_eng\gtcproddocs\standard ioms - current release\42003 kit manuals\42003-035b.doc
Installation of new cord
1. Feed the red and green wires through the transmitter end of the handset, through the center of the
handset receiver end. Place the brass eyelets on the receiver as indicated in Figure 2. Feed the screws
through the handset PCBA through the eyelet and into the receiver. Secure the wires as indicated in
Figure 2.
2. Place the receiver in the cup. Tighten the
receiver cap. For stations with a pressbar
handset, proceed to Stop 3. For stations
without a pressbar handset, proceed to
Step 8.
3. Feed the yellow and blue wires through
the handset to the pressbar area.
4. Secure the wires to the terminals in the
plastic cup. Place the plastic cup in the
handset.
5. See Figure 1 above. Place the copper
piece with the rubber center in first, with
the solid rubber side facing up and the
notch in the appropriate slot.
6. Place the other copper piece so that the bend faces out.
7. Place the plastic piece such that the GTC logo side is facing up. Place the metal bracket on top and
tighten the screws.
8. FOR HANDSETS WITHOUT A PRESSBAR ONLY: Snip off the blue and yellow wires as close to
their origin as possible.
9. Attach the wires to the transmitter terminals.
10. Place the transmitter in the transmitter cap, making sure that the cord guide snaps firmly onto the cord
to secure it. Screw on the transmitter cap.
11. Feed the end of the cord through from the front panel of the phone and use the Heyco® bushing tool
or needlenose pliers to secure the bushing on the amplifier front.
12. Connect the wires to the PC board: red to E4, white to E1, black to E2, yellow to E5, blue to E6 and
green to E3. Stations without pressbar handsets will not have the blue and yellow wires.
13. Secure the backbox by tightening the four screws.
14. Reinstall the amplifier into the enclosure.
Figure 2. Receiver Detail for 701 Models