GAI-Tronics LE300-IP Page/Party Line Extender - Manual (Page 15)

Pub. 42004-488C
M ODEL LE300-IP P AGE /P ARTY
®
L INE E XTENDER P AGE 12 of 68
e:\standard ioms - current release\42004 instr. manuals\42004-488c.doc
09/14
Party Line Off-Hook Detection
The Model LE300-IP Line Extenders provide off-hook detection on the local Page/Party ® system cable for
party lines 1 through 5. An off-hook condition means a handset station is in use. If multiple line extenders
are connected to the same Page/Party
® system cable segment, only one off-hook detector can be enabled.
If connecting an LE300-IP to the same system cable segment as an ADVANCE Page/Party ® Interface
(PPI) card, disable the LE300-IP off-hook detection for party lines 1 and 2. The PPI card contains off-
hook detection for party lines 1 and 2.
Several shorting clips (P6–P15) are used to enable the off-hook detection feature on party line 1 through 5.
Two shorting clips are associated with each party line and must be set to the same position for proper
operation. The party lines 1 through 5 are configured independently. Refer to Figure 6 for the location of
P6–P15 on the Main PCBA and Table 11 below for setting options.
Table 11. Party Line Off-Hook Detection Setting on Main PCBA
Party Line Headers Shorting Clip Off-Hook Detection
Party Line 1 P15, P14
Pins 1–2* Disabled
Pins 2–3 Enabled
Removed Disabled
Party Line 2 P13, P12
Pins 1–2* Disabled
Pins 2–3 Enabled
Removed Disabled
Party Line 3 P11, P10
Pins 1–2* Disabled
Pins 2–3 Enabled
Removed Disabled
Party Line 4 P9, P8
Pins 1–2* Disabled
Pins 2–3 Enabled
Removed Disabled
Party Line 5 P7, P6
Pins 1–2* Disabled
Pins 2–3 Enabled
Removed Disabled
N OTES :
1. Changes to this parameter take effect without cycling power.
2. *Indicates default position.