GAI-Tronics VoIP Telephone Software Configuration Guide User Manual
Voip telephones
Table of contents
Document Outline
- Pub. 42004-396C
- Contents
- 1. Introduction
- 2. What's new ?
- 3. How the product is intended to work
- 4. Setting up and Configuring the telephones
- 4.1 Quick Start
- 4.2 Frequently Asked Questions (FAQs)
- 4.2.1 What network facilities do I need to provide?
- 4.2.2 How do I set up dialling and memory lists?
- 4.2.3 Can I set the phone to make calls without a proxy (ie peer-topeer)?
- 4.2.4 How do I set up Real-time alarm reporting via email or syslog?
- 4.2.5 How can I set up an external beacon to flash when the phone isringing?
- 4.2.6 How do I set up a door-entry system?
- 4.2.7 How can I use the phone to make paging or PA announcements?
- 4.2.8 What additional features are available with CMA?
- 5. Web pages in detail
- 5.1 Login
- 5.2 Home Page
- 5.3 IP settings
- 5.4 SIP settings
- 5.5 Unit settings
- 5.6 Access settings
- 5.7 Serial settings
- 5.8 Email settings
- 5.9 Clock settings
- 5.10 Dialling & Memories
- 5.11 Key mapping
- 5.12 Current status
- 5.13 Audio settings
- 5.14 Alarm settings
- 5.15 Tone settings
- 5.16 LED settings
- 5.17 Logic settings
- 5.18 Multicast settings
- 6. Configuration File update
- 7. Time Zone Table
- 8. Example Configuration File
- 9. Command Line Interface
- 9.1 CLI Syntax
- 9.2 ACCESS Module Command Line Syntax
- 9.3 ALARMS Module Command Line Syntax
- 9.4 KEY Module Command Line Syntax
- 9.5 LED Module Command Line SyntaxActionVerbParameters
- 9.6 DIALPLAN Module Command Line Syntax
- 9.8 CLOCK Module Command Line Syntax
- 9.9 AUDIO Module Command Line Syntax
- 9.10 TONES Module Command Line
- 9.11 IP Module Command Line Syntax
- 9.12 LOCAL Module Command Line SyntaxActionVerbParameters
- 9.13 LOGIC Module Command Line Syntax
- 9.14 SIP Module Command Line Syntax
- 9.15 SMTP Module Command Line Syntax
- 9.16 Status Module Command Line SyntaxActionVerbParametersComment
- 9.17 UNIT Module Command Line SyntaxAction Verb ParametersComment
- 9.18 Multicast Module Command Line Syntax
- 10. Reset to Defaults
- 11. Troubleshooting
- 12. Licensing Notices