Operation, Lcd display at initial power up – GAI-Tronics 10959-201 and 10959-203 Wall-mount Audio Messenger Interface User Manual
Page 16
Pub. 42004-403F
M
ODEL
10959-201
AND
-203
W
ALL
-M
OUNT
A
UDIO
M
ESSENGER
I
NTERFACES
P
AGE
14 of 20
f:\standard ioms - current release\42004 instr. manuals\42004-403f.doc
11/13
Operation
Once the CompactFlash
®
is programmed and installed into the unit, the unit operates based on system
inputs and outputs or by manual operation.
LCD Display at Initial Power Up
At initial power up, the AMI unit completes a self-diagnostic of its settings. The LCD display cycles
through the following messages:
AMI firmware version
Boot DSP
Media detected
EEPROM firmware version
DSP firmware version
Progress bar/LOAD CONFIG
Configuration version
Configuration date and time
Configuration file name
HIO (I/O control module) board firmware version or “HIO not installed.”
ASM (Zone Interface Module) board firmware version or “ASM not installed.”
Page/Party
®
board firmware version
AMI Main board firmware version
Telephone Interface Mode (if telephone interface installed)
Telephone Interface Board firmware version or “Telephone Interface not installed.”
Telephone Interface Greeting file name (if recording a new greeting)
AMI ready
Time, page symbol/date