GAI-Tronics WCB104 Wireless Call-Box Installation Guide - Manual (Page 7)

Pub. 42004-327A
Model WCB104 Wireless Call Box Installation Guide Page: 7 of 10
\\s_eng\gtcproddocs\standard ioms - current release\42004 instr. manuals\42004-327a.doc
12/00
Operational Check
Outbound Calls
1. Open the front door and verify the illumination LEDs are ON.
2. Remove the handset from the cradle and verify dial tone is present in the receiver.
3. Depress the P OLICE autodial button.
• Ringing will broadcast in the receiver.
• The C
ALL P LACED LED flashes until communication with the network is established. At that
point, the C ALL P LACED LED will be lit steadily.
4. Once the Call Center has answered, the ANI and Button ID Number will be transmitted (this will be
audible in the handset receiver).
5. When the C ALL C ONNECTED LED illuminates, communication with an operator will be enabled.
6. Return the handset to the cradle to terminate the call.
7. Perform steps 2 through 6 for autodial buttons F IRE , A MBULANCE , and T OW T RUCK .
Inbound Calls
1. Place a call to the Call Center and request a call back from the operator.
2. The ringer will sound.
3. Remove the handset from the cradle.
4. Communication with an operator will be enabled.
5. Depress the volume control. The receiver volume increases with each depression. On the 5
th
depression, the receiver volume returns to the default setting.
6. Return the handset to the cradle to terminate the call.