GAI-Tronics WCB104 Wireless Call-Box Installation Guide - Manual (Page 2)

Pub. 42004-327A
Model WCB104 Wireless Call Box Installation Guide Page: 2 of 10
\\s_eng\gtcproddocs\standard ioms - current release\42004 instr. manuals\42004-327a.doc
12/00
Installation
The 4-inch O.D. pole must be installed in accordance with the applicable state highway regulations for
emergency access equipment. Figure 2 on page 3 shows a pole with the finished installation including the
call box with mounting bracket, the signs with mounting bracket, the pole cap, antenna, and solar panel.
Pole Mounting
Assemble the following required materials and tools:
• Model 238 Pole-Mounting Bracket Kit
(Quantity of 2)
• Model RFP7791-001 External Ringer Kit with Stainless Steel Ringer Bracket
• Model RFP7783-002 Antenna Kit
• Model RFP7783-003 Pole Cap Assembly Kit
• Identification signs and mounting hardware, as appropriate for location
• Drill, with 1-inch bit
• Torque wrench
• ¾-inch socket with ratchet
• Crimp tool for TNC coaxial connector
• Wire cutters
• Coaxial cable stripper
Install the Pole-Mounting Bracket for the Call Box
Mount the required Model 238 Pole-Mounting Bracket for the call box in accordance with the instructions
given in GTC Publication 42003-187, which is included with the kit.
Install the Pole-Mounting Mounting Bracket for the Signs
Mount the second Model 238 Pole-Mounting Bracket for the identification signs in accordance with GTC
Publication 42003-187, which is included with the kit.
Attach the Completed Pole Cap Assembly
The Model RFP7783-003 Pole Cap Assembly Kit contains the materials required to install the solar
panel, cellular antenna, and the external ringer onto the pole. The solar panel is included with the pole
cap assembly kit. The antenna and ringer are purchased separately. Assemble the kit and install on the
pole in accordance with GTC Publication 42003-188, which is included with the kit.