FSR IT-R4S - Manual (Page 8)

8
“RS”
Where:
“RS”
Relay Status Request.
Relay Response:
The Relay status response will display only what was requested and the configuration
dipswitch 4 status.
“RS”
Ver Relay Status Serial 2 baud
Where:
“RS”
Relay Status Response.
Ver Version Number
Relay Status relays current status
Serial2 Baud “1” = 2400
“2”
= 4800
“3” = 9600
“4” = 19200
“5” = 38400
“6” = 57600 (MAS-6200)
The user sends “RS the IT-R4S would respond with “RS R1=O R2=C R3=P R4=O
SB=5”. This response means that relay1 is Open(off), relay2 is on Closed(on), relay3 is
currently being (P)ulsed, relay 4 is Open (off), and Serial 2 baud rate is 38400.
Serial 2-Baud Rate Request:
It may be necessary to change the baud rate on the last pass-through device serial port.
This may happen if the last device doesn’t have the baud rate at 38400, and doesn’t have a
method to change it.
“RB”
Port Baud rate number
Where:
“B”
Change baud rate request
Port Serial port number (“2” for IT-R4S)
Baud rate number Which baud rate to change to:
“1” = 2400
“2” = 4800
“3” = 9600
“4” = 19200
“5” = 38400
“6” = 57600 (MAS-6200)
The IT-R4S will respond to this request with a status message.