FSR DV-HMSW-88 8x8 MATRIX - Manual (Page 9)

9
4 OPERATION
4.1 Product ID settings
(1) When using the Configure key on front panel
Push configure the (Config) key on front panel -> push the Select (Select) key until the LCD shows the number you
want (Rotating number)
(2) When using the Dip switch on the back panel

Dip switch sets address for each matrix if many matrixes are used.

Dip switch sets a binary value.
Ex)
Product ID = 01 (00000001b) -- 1 ON, 2 OFF, 3 OFF, 4 OFF, 5 OFF, 6 OFF, 7 OFF, 8 OFF,
Product ID = 10 (00001010b) -- 1 OFF, 2 ON, 3 OFF, 4 ON, 5 OFF, 6 OFF, 7 OFF, 8 OFF,
Product ID = 23 (00010111b) -- 1 ON, 2 ON, 3 ON, 4 OFF, 5 ON, 6 OFF, 7 OFF, 8 OFF

The product number is the value set on the dip switches of the equipment and can be any value from 1 ~
255. The value “0” is not available.
**The product ID is set number “1” at the time of its delivery (Factory Default).
4.2 Initialization
On initial power on, the preview buttons are displayed with 2 steps as follow.
If each preview button is lit, then the initialization is completed.
(1) Initialization display
Check each input port to see whether EDID is saved in the port
If EDID data is saved, LED of input button is lit for about 4 seconds.
----------- INPUT ----------------- ---------- CONTROL -----------
1 2 3 4 5 6 CREATE PREVIEW ENTER CANCEL EDID
CRE PRE ENT CAN EDI
1 2 3 4 5 6
----------- OUTPUT -----------------
(2) Channel display and input selection
After the initialization, preview button is lit.
----------- INPUT ----------------- ---------- CONTROL -----------
1 2 3 4 5 6 CREATE PREVIEW ENTER CANCEL EDID
1 2 3 4 5 6 7 8
D0 D1 D2 D3 D4 D5 D6 D7
LSB MSB