Foxconn P35AP-S User Manual

Page 43

Chapter 3 BIOS Description

8.7

***Miscellaneous***

Auto Detect PCI Clock
This item is used to set whether allow the system to supply the PCI slot bus
clock if system detected PCI add-on card on the slot.

Spread Spectrum
If you enable spread spectrum, it can significantly reduce the EMI (Electro-
Magnetic Interference) generated by the system.

Over Clock Recovery
Enable this item ,when the system fail in over-clock,BIOS will recover the
default settings automatically.

Smart Boot Menu
This item is used to enable or disabled the smart boot menu.

Smart Power LED

This item is used to enable or disabled the smart LED.

10. Load Optimized Defaults

Select this option and press Enter, it will pop out a dialogue box to let you load
the optimized defaults set by BIOS. Select and then press to load
the optimized defaults. Select and press , it will not load. The de-
faults set by BIOS have set the optimized performance parameters of system to
improve the performances of system components. But if the optimized perfor-
mance parameters to be set cannot be supported by your hardware devices, it
will cause system to make mistakes or not stable. If you only want to load the
optimized defaults in an option, you can select this option and press the key
.

9. Load Fail-Safe Defaults

Select this option to press , it will pop out a dialogue box to allow you to
load default set by BIOS. Select and then press Enter to load default. Select
and press , it will not load. The defaults set by BIOS have set the
basic functions of system in order to ensure the stability of system. But if your
computer fails to properly run, you may load the default to make the system
recover normal, then carry out failure testing in next step. If you only want to load
the default in an option, you can select this option and press the key .

11. Set Supervisor/User Password

The access rights and permissions associated with the Supervisor password are
higher than those of a regular User password. The Supervisor password can be
used to start the system or modify the CMOS settings. The User password can
also start the system. While the User password can be used to view the current

PDF 文件使用 "pdfFactory" 试用版本创建