Foxconn P35AP-S User Manual

Page 36

Chapter 3 BIOS Description

5.4 ACPI Suspend Type

This item is used to set the energy saving mode of the ACPI function.
W hen you select “S1 (POS)” mode, the power will not shut off and the
supply status will remain as it is, in S1 mode the computer can be resumed
at any time. When you select “S3 (STR)” mode, the power will be cut off after
a delay period. The status of the computer before it enters STR will be saved
in memory, and the computer can quickly return to previous status when the
STR function wakes.When you select “S1&S3” mode, the system will
automatically select the delay time.

5.5

Run VGABIOS if S3 Resume

This item allows the system to initialize the VGABIOS from S3 (Suspend to
RAM) sleep state. The available setting values are: Auto, Yes and No.

5.6

Soft-Off by PWR-BTTN

This item is used to set the power down method.This function is only valid
for systems using an ATX power supply. When set to [Delay 4 Sec.], the power
button is used to put the system in Suspend mode if you press the power
switch less than 4 Sec.. If set to [Instant-Off], the PC power off completely
when the power button is pressed.

5.7

Resume by Alarm

This item is used to set the timing of the start-up function. In order to use this
function, the start-up password function must be canceled. Also, the PC power
source must not be turned off.

5.8

Date (of Month) Alarm

When the Resume by Alarm set as “Enabled”, this item will be modified. It is
used to set the timing for the start-up date.

5.9

Time (hh:mm:ss) Alarm

When the Resume by Alarm set as “Enabled”, this item will be modified. It is
used to set the timing for the start-up time.

5.10

HPET Support

This item is used to enable or disable the HPET Support.

5.11

HPET Mode

This item is used to set the HPET Mode. Configration options: [32-bit mode];
[64-bit mode]. It can be availabled only when the HPET Support is enabled.

5.12

PWRON After PWR-Fail

This item is used to set which state the PC will take with when it resumes
after an AC power loss.Setting values:[Off]; [On];[Former-Sts].

PDF 文件使用 "pdfFactory" 试用版本创建