4 install a new windows xp – Foxconn Quantumian1 User Manual

Page 99

5-4 Install a New Windows XP

1. Press to enter BIOS Setup during POST.
2. Insert the Windows installation CD into the optical drive.
3. Set the “1st Boot” to “CD/DVD”, save changes and exit the BIOS setup.

4. The computer will reboot, and it will start installing Windows Operating System.
Watch the screen carefully, when the following picture appears, press key

immediately. If you forgot to do this, PC will go to an fatal blue screen, and you
may need to reboot the system again. PC may not respond to your input
immediately, and it keeps loading files until the next screen displays.

Windows Setup

Press F6 if you need to install a third party SCSI or RAID driver.

When set the SATA Mode in BIOS to IDE, you can install Windows XP directly.

When set the SATA Mode in BIOS to either AHCI or RAID, you need to
follow the following steps to install Windows XP.

Main Advanced Quantum BIOS Boot Security Save & Exit

Boot Configuration

Quiet Boot

[Disabled]

Fast Boot

[Enabled]

Bootup Numlock State

[On]

UEFI Boot

[Disabled]

Set Boot Priority

1st Boot

[CD/DVD]

2nd Boot

[Hard Disk]

3rd Boot

[USB Flash]

4th Boot

[USB Floppy]

5th Boot

[USB CD/DVD]

6th Boot

[USB Hard Disk]

7th Boot

[Network]

8th Boot

[UEFI]

→ ←: Select Screen
↑ ↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values

F3: Optimized Defaults
F4: Save & Exit
ESC: Exit

Enables or disables Quiet Boot
Option

Boot