Foxconn Quantumian1 - Manual (Page 104)

5
97
2. Copy section 5-2, BIOS Configuration.
Shut down the computer, connect SATA hard disks to SATA ports, power on
computer again.
Press key, get into BIOS, set "SATA Mode" to [RAID Mode], press to
save and exit BIOS. PC will reboot.
3. Copy section 5-3, Create RAID in BIOS.
Press simultaneously to get into RAID BIOS set up (Intel
®
Rapid Stor-
age Technology enterprise utility).
Configure your new hard disks to RAID0, 1, 5 or 10. Exit RAID BIOS. PC will reboot.
4. The Windows XP is running again and a new hardware of RAID disk was found.
Click [Cancel] to skip this Wizard.
Click to exit.
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
SATA Configuration SATA Configuration
SATA Mode [RAID Mode]
SATA Port 0
Not Present
Port Hot Plug [Disabled]
SATA Port 1
Not Present
Port Hot Plug [Disabled]
SATA Port 2
Not Present
Port Hot Plug [Disabled]
SATA Port 3
Not Present
Port Hot Plug [Disabled]
SATA Port 4
Not Present
Port Hot Plug [Disabled]
→ ←: Select Screen
↑ ↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
(1) IDE Mode.
(2) AHCI Mode.
(3) RAID Mode.
Enabled onboard SATA RAID
option ROM if Launch Storage
OpROM is enabled.
Advanced