Foxconn Quantumian1 - Manual (Page 102)

5
95
9. Windows will display the partition of your system, you have to create partitions as
many as you wish, assign them C:, D: or E: drive names. After partitions were done,
you can press to continue. It will ask you to format your hard disk, then
copy files...etc., until the whole Windows is setup.
10. You must always keep RAID diskette in the floppy drive during Windows XP
installation, otherwise, Windows may ask you to put it inside again by below
message. There are many times Windows XP may copy files from the floppy drive,
please remember.
11. Follow the Windows XP install processes to finish the set up.
Windows XP Professional Setup
The following list shows the existing partitions and
unpartitioned space on this computer.
Use the UP ad DOWN ARROW keys to select an item in the list.
● To set up Windows XP on the selected item, press ENTER.
● To create a partition in the unpartitioned space, press C.
● To delete the selected partitions, press D.
305251 MB Disk 0 at id 0 on bus 0 on iaStor [MBR]
ENTER=Install C=Create Partition F3=Quit
Unpartitioned space 305251 MB
Windows XP Professional Setup
Insert the disk labeled:
Intel Rapid Storage Technology enterprise driver
into drive A:
* Press ENTER when ready
F3=Quit ENTER=Continue