Foxconn NF3250K8AA-ERS - Manual (Page 43)

36
Chapter 3 BIOS Description
NF3250K8AA/NF3250GK8AA Series User Manual
v KB Power ON Password (Default: Enter)
When the POWER ON Function is set to Password, use this item to set the
password.
v Hot Key Power ON (Default: Ctrl-F1)
When the POWER ON Function is set to Hot KEY, use this item to set the hot
key combination that turns on the system. The available setting values are:
Ctrl-F1-F12.
v Onboard Serial Port 1/2 (Default: 3F8/IRQ4/2F8/IRQ3)
This option is used to assign the I/O address and interrupt request (IRQ)
for the onboard serial port 1/2.
Note: Do not try to set the same values for serial port 1 and 2.
v UART Mode Select (Default: Normal)
Use this option to select the UART mode. The setting values include Normal,
IrDA, ASKIR and SCR. The setting value is determined by the infrared module
installed on the board.
v UR2 Duplex Mode (Default: Half)
This option is available when UART 2 mode is set to either ASKIR or IRDA. This
option enables you to determine the infrared (IR) function of the onboard infra-
red chip. The available setting values are: Half and Full.
v Onboard Parallel Port (Default: 378/IRQ7)
This option is used to assign the I/O address and interrupt request (IRQ) for
onboard parallel port controller. The setting values include: Disabled, 378/
IRQ7, 278/IRQ5 and 3BC/IRQ7.
v Parallel Port Mode (Default: SPP)
Select an address and corresponding interrupt for the onboard parallel port.
The setting values include SPP, EPP, ECP, ECP+EPP.
v PWRON After PWR-Fail (Default: Off)
This option is used to set what action the PC will take with the power supply
when it resumes after a sudden power failure. The available options are: Off
(remain in turn off status). On (auto power on) and Former-Sts (resume with
the previous status).