Foxconn NF3250K8AA-ERS - Manual (Page 22)

15
Chapter 2 Installation Instructions
NF3250K8AA/NF3250GK8AA Series User Manual
This motherboard includes interfaces for FLOPPY, IDE devices, SATA devices,
USB devices, 1394 devices, IR module, CPU fan, system fan, and others.
FLOPPY
This motherboard includes a standard FLOPPY interface, supporting 360 K, 720 K,
1.2 M, 1.44 M, and 2.88 M FDDs.
HDD connectors: PIDE & SIDE
These connectors support the provided UltraDMA 133/100/66/33 IDE hard disk
ribbon cable. Connect the cable’s blue connector to the primary (recommended)
or secondary IDE connector, then connect the gray connector to the UltraDMA
133/100/66/33 slave device (hard disk drive) and the black connector to the
UltraDMA 133/100/66/33 master device. If you install two hard disks, you must
configure the second drive as a slave device by setting its jumper accordingly.
Refer to the hard disk documentation for the jumper settings.
Other Connectors
Attention:
Ribbon cables are directional, therefore, make sure to always con-
nect with the cable on the same side as pin 1 of the PIDE/SIDE or
FLOPPY connector on the motherboard.
Front Panel Connector: FP1
This motherboard includes one connector for con-
necting the front panel switch and LED indicator.
FP FP1 !
IDE_LED RESET
PLED PWRBTN#
1
+ -
NC
+ -