Formax FD 2000IL System - Manual (Page 8)

4
PRINTER ALIGNMENT BASE SETUP
The Printer Alignment Base comes with two sets of alignment pins.
The pins at the top in the photo below are used with the FD 2000-46IL and FD 2000-45IL risers for HP/Troy
P2015 and Lexmark/Source T640 printers. The printer is then set on top of the riser, using the pins located on
the riser itself (see page 5, fi gure 8b).
The left pin can be adjusted to properly align the riser and printer with the sealer.
1. Loosen the left pin using an adjustable wrench to hold the pin while using a 7/16” socket to loosen the nut.
2. To move the front outfeed corner of the printer forward toward the front edge of the alignment base, slide the
pin forward.
3. To move the front corner of the printer back away from the edge of the alignment base, slide the pin
backward. The printer will pivot on the right alignment pin (Fig. 6).
The bottom pins shown in Fig. 6 are used with HP/Troy P3005 printers. In this application, the top pins should
be removed.
Fig. 6
Edge facing pressure sealer
Alignment pins for use with
HP/Troy P3005 laser printer
Alignment pins for use with
FD 2000-45IL and FD 2000-46IL
risers
Alignment pins for use with
HP/Troy P3005 laser printer
Alignment pins for use with
FD 2000-45IL and FD 2000-46IL risers