Formax FD 2000IL System - Manual (Page 11)

7
1. Plug in cord and turn on power for both the pressure sealer and laser printer.
2. Place pressure seal forms in printer paper tray. Paper should be loaded into the approved printers face
down with the glue edge trailing. Locate the paper orientation guide on the printer and load accordingly (Fig.
12). The print side glue edge is considered the top of the document. Once forms are loaded perform an offl ine
print test (see pg. 9) to make sure the printer and sealer are aligned properly. If the print test is satisfactory
begin online operation.
3. Adjust fold plates to desired fold for length of paper
(see fold plate adjustment on page 8). To do this, fi rst
loosen two thumbscrews on each fold plate. Align
center bar so the marks on each side match up.
For “V” folds remove the lower fold plate,
turn it around 180 O and reinstall.
4. Make sure covers are closed properly.
5. Perform offl ine print test (page 9). Press jog switch
to make sure folds are correct, adjust if necessary
(see fold plate adjustment, page 8).
CONTROL PANEL
Fault Reset .............. Clears “fault” condition.
Jog ........................... Allows one piece of paper to feed at a time. Used for paper fold settings.
Power LED ............... Light comes on when power is on.
Cover Open LED ...... Light comes on if either top cover or side cover is open.
Fault Detect ............. Light comes on if there is a paper jam.
Counter Reset .......... Resets counter.
Counter..................... Shows forms count.
OPERATION
Printer Paper
Orientation Guide
Fig. 12