Formax FD 2000IL System - Manual (Page 17)

13
Custom fold is misfolding Wrong fold is selected
Fold plates are not inserted
correctly.
Piece of paper or other material
is stuck in the fold plate.
Fold plate is not set properly
Check to make sure the fold “bars” line up
with the correct fold settings. See page 8 for
Custom Fold Settings.
Remove and reinstall fold plates. Be sure
they’re properly positioned.
Remove object from the fold plate.
Check that the fold settings match the actual
fold lengths, (see page 8).
Fault Detect LED is lit Paper misfeed between printer
outfeed and sealer infeed
Paper jammed in pressure
sealer infeed deck
Paper jammed at steel sealer
rollers.
Slide printer back to gain access to the
printer outfeed and remove forms. Lift top
cover of printer, remove toner cartridge and
remove forms. Reinstall toner, close printer
cover, slide printer back into position and
press the “fault reset” button on sealer to
reset sealer.
Slide printer back to gain access to sealer
infeed. Lift transport deck cover and remove
jammed document. With one hand hold
transport deck, and with the other, release
the transport deck release handle and slowly
lower the cover back into place. (See page
14 for procedure.)
Remove paper and press “fault reset”
button, see pg 14 for clearing instructions.
Black marks on the folded
forms.
Fold rollers and/or steel sealer
rollers are dirty.
Clean the rollers with approved roller cleaner
and rejuvenator.
Fold is skewed. Printer and sealer are out of
alignment.
Transport deck belts are dirty
Check to be sure the printer and sealer are
set properly on the alignment pins
Adjust rear pin on the printer alignment
base, (see pg 4 for adjustment procedure)
Clean belts with approved cleaner
Transport table belts do
not turn.
Broken drive belt, worn drive
gear.
Call for service
Documents are wrinkled
or crunched.
Fold plates are not inserted
correctly.
Piece of paper or other material
is stuck in the fold plate.
Remove and reinstall fold plates. Be sure
they’re properly positioned (see page 3).
Remove object from the fold plate.