Formax FD 2000IL System - Manual (Page 6)

2
SETUP
Fig. 1
Fig. 2
Fig. 3
2. Extend connecting slider and slide into slot on
sealer section of base, lining up the screw holes
with the holes in the top of the base (Figure 2).
Insert the leading two screws fi rst, do not tighten
down at this point.
Align third screw hole in the slider with the top
cover and insert screw.
Tighten all three screws into place.
1. Align the 2000IL with the pins located on the
alignment base and lower into position. (Figure 3)
Caution: Two people should lift and lower the
2000IL.
1. Place two parts of alignment base face up.
(Figure 1).
Alignment Base, Pressure Sealer Section
Alignment Base, Printer Section
Connecting slider
Alignment Base Setup
Sealer Setup