Flowserve 500+ Series Logix - Manual (Page 25)

User Instructions - Logix® 500+ Series Digital Positioners FCD LGENIM0105-10 11/13
flowserve.com 25
7.4 Limit Switches
Limit switches provide an independent verification of the
position of the feedback shaft. Wire the limit switches
according to Table 14: Limit Switch Connections. For more
information, see Table 7: Limit Switch Specifications on page
9.
Figure 29: Limit Switch Board
Table 14: Limit Switch Connections
Terminal (See Figure 29)
Switch 1 2 3 4 5 6
Mechanical
Cherry DG 13-B2RA
1 & 4 NC NC NO C NC NO C
+ + - + + -
LS1 LS2
Reed
Hamlin 59165-1-S-00-C
NO + - + -
LS1 LS2
Inductive Sensor
P&F NJ2-V3-N
NAMUR NC BN BU BN BU
+ - + -
LS1 LS2
Inductive Proximity
P&F SJ2-S1N
BN BU BN BU
NAMUR NO + - + -
LS1 LS2
Inductive Proximity
P&F SJ2-SN
BN BU BN BU
NAMUR NC + - + -
LS1 LS2
Inductive Sensor
P&F NBB2-V3-E2
PNP NO BN BU BK BN BU BK
General Purpose Only Vcc+
- SW+ Vcc+ - SW+
LS1 LS2
7.5 Remote Mount
The remote mount option can be used where excessive
vibration or environmental factors prevent the placement of a
positioner directly on the valve. Wire the remote mount
board according to Table 15: Remote Mount Card
Connections. For more information, see Table 6: Remote
Mount Specifications on page 8.
Figure 30: Remote Mount Board
Table 15: Remote Mount Card Connections
Terminal (See Figure 30:
Remote Mount Board)
A B C
From Remote Mount Red White Black
7.6 Connections for Intrinsically Safe
Operation
See section 3 HAZARDOUS AREA CERTIFICATIONS for
entity parameters and control drawing reference.
LS1
LS2
Terminals
Terminals