Fire Magic Echelon Diamond Stand Alone Grill - Manual (Page 38)

38
CONVERTING THE GAS TYPE
3. Unfasten the two back burner nuts (found on the left
side of the back burner) using a 1 /
4
" nut driver and
set them aside. See Fig. 38-2.
4. Remove the back burner by lifting the left side
outward and to the left. See Fig. 38-3.
5. Use a 3 /
8
" hex nut driver to remove the exposed orifi ce
and replace it with the correct orifi ce for the gas being
converted to (See Table 1 for size). Reference Fig.
38-4 for orifi ce orientation.
6. Replace the back burner assembly and fasten the
two nuts using a 1 /
4
" nut driver.
7. Replace the back burner cover and warming rack.
Fig. 38-1
Fig. 38-3
Fig. 38-4
Fig. 38-2
Orifi ce
CHANGING AN INFRARED BURNER ORIFICE
(IF EQUIPPED)
1. Remove the cooking grid from above the burner on
which you are working by lifting it fi rst from the front
and set it aside.
2. Unscrew both lighting tube hex head screws with a
3 /
8
" hex nut driver.
3. Remove the infrared burner by lifting the back of the
burner up so that both tabs are freed from their slots,
then lift the burner toward the back of the fi re box
and upward. Set the burner aside.
4. Use a 3 /
8
" hex nut driver to remove the exposed orifi ce
and replace it with the proper orifi ce for the new gas
(see Table 1 for sizing).
5. Replace the infrared burner by fi rst sliding it over the
orifi ce, then lowering the two tabs under the back of
the burner into the slots in the back burner rest.
6. Reattach the lighting tube and replace the grid so
that the cut-out section is in front.
CHANGING THE SINGLE SIDEBURNER ORIFICE
1. Lift the sideburner lid. Then remove the grill and
sideburner cap and set them aside.
2. Locate and remove the cotter pin from the
sideburner assembly underneath the sideburner
shelf using needle-nose pliers. Set it aside.
3. From the top of the sideburner shelf, lift the
sideburner upward while rotating the attached
tubing underneath away from the orifi ce near the
cart wall. Set it aside.
4. Use the nut driver to remove the exposed orifi ce
and replace it with the correct orifi ce for the gas
being converted to. (See Table 1 for correct orifi ce
sizes based on burner type and gas type.)
Note: To protect the manifold threads when placing
the new orifi ce, start the threading manually,
and then tighten with the nut driver.
5. Rotate the burner assembly back into place over
the orifi ce and fi rmly seated in the shelf.
6. Reinsert the cotter pin underneath the sideburner
assembly using needle-nose pliers. It may be
necessary to push downward on the burner
assembly from above to fully expose the cotter
pin hole. Rotate the inserted cotter pin so that it
is fl ush with the underside of the shelf.
7. Replace the burner cap by centering it on the
sideburner assembly and making sure it drops in
place.
8. Replace the grill with the grating running front to
back so that it drops fully down onto the shelf,
allowing the lid to close completely over it.
Fig. 38-3
Cotter
pin