Fire Magic Echelon Diamond Stand Alone Grill - Manual (Page 36)

36
POWER SUPPLY FUSE REPLACEMENT
1. The power supply box is located on the right
side of the grill (reference the PARTS LIST).
2. Using a phillips screwdriver, remove the 6 large
screws found on the cover of the power supply
box (see Fig. 36-1).
3. Slightly pull out the box to expose the wiring,
and disconnect the wire harness (see Fig. 36-2).
Completely remove the box from the grill for
ease of fuse replacement.
4. Remove the 4 small screws found on the cover
of the power supply box (see Fig. 36-3).
Note: The 2 center screws do not need to be
removed.
5. Carefully open the box by pulling its cover away.
You may need to feed the wire harness into the
box to provide enough slack to open on the
other end. Then “push in and twist” the fuse
holder (red wire), exposing the fuse. See Fig.
36-4.
6. Replace the fuse accordingly (3AG 2 AMP).
Slightly pull out box and disconnect wire harness
Fig. 36-2
Disconnect
here
Remove 6 large screws
Fig. 36-1
Carefully open box and replace fuse (red wire)
Fig. 36-4
Remove 4 small screws
Fig. 36-3