Exacq exacqVision E-Series User Manual - Manual (Page 28)

28 www.exacq.com
Configuring SNMP Settings
Simple Network Management Protocol (SNMP) is an Internet-standard protocol for managing devices on IP networks. If
your environment uses a network management system, you can use SNMP to get camera status, parameters, and alarm-
related information.
1. Before setting the SNMP, download the SNMP software. By setting the Trap Address, the device can send the
alarm event and exception messages to the surveillance center.
2. From the Remote Configuration menu, select Network Settings and then SNMP to enter the SNMP settings
interface.
3. Select SNMP v1 or SNMP v2c. You can enable both SNMP v1 and SNMP v2c.
4. Configure the Read SNMP community (default: public)
5. Configure the Write SNMP community (default: private)
6. Configure the Tap Address (default: [blank])
7. Configure the Trap Port (default: 162).
The rest of the SNMP configuration is discussed on the following page.
3
2
4
5
6
7