Exacq exacqVision Pro User Manual - Manual (Page 38)

38 www.exacq.com
Mechanical PTZ Tab
This tab contains two additional tabs: Settings and Presets.
The Settings tab allows you to configure the COM port and address of the PTZ camera.
1. Select the camera’s COM port from the Serial Port drop-down list. This port is configured on the Serial Ports
page.
2. Select the camera’s Address as configured on the camera hardware. (The protocol is automatically displayed
based on the Serial Port selected.)
3. To create a dome pattern (available only on certain analog cameras), click Record (3a), use the PTZ controls (3b)
to move the camera in the pattern desired, and click Stop. Click Run (3c) to review the pattern. Use the number
indicator (3d) to create additional dome patterns.
1
2
3a
3b
3c 3d