Acti – Exacq exacqVision IP Camera Quick Start Guide User Manual
Page 5
www.exacq.com
#500-0024
+1.317.845.5710
+44.1438.310163
USA (Corporate Headquarters)
Europe/Middle East/Asia
Page 5 of 17
7/15/2014
2
ACTi
ACTi provides the ACTi IP Utility to find IP cameras. This is located on the installation CD in the \Professional\Utility\IP
Utility.exe directory. You might need to install the ACTi Streaming Activator Software from the CD to find the ACTi IP utility.
Run the utility to display the following window:
Enter the Account name and Password in the appropriate fields, and then click Configure Camera Settings (the wheel button
at the far left side of the row).
Change the WAN IP address to an IP address that is not used on your network. You cannot turn on DHCP here; that can be
done only on the camera webpage. After you enter the IP address and subnet mask entered, click Apply and Save & Reboot.
NOTE: The factory default login for ACTi IP cameras is:
username: Admin
password: 123456
You will need the username and password when you add this camera to your exacqVision system.