ETA Koloro - Manual (Page 44)

44
GB
3) Make sure that the supply cord is not damaged and does not go through the oven
or through any other sharp or hot places. The el. outlet must be easily accessible in
order that the oven can be easily disconnected from the el. outlet in case of danger.
The appliance is equipped with a supply cord with protective conductor. The fork
must be plugged into a properly wired and grounded socket according to EN!
We recommend using an individual electric circuit with a safeguard 16 A.
4) Do not remove the light brown coverthat is attached to the oven cavity to protect the
magnetron.
5) Place the oven as far away from radios and TV as possible. Operation of microwave
oven may cause interference to your radio or TV reception.
Each oven comes with a removeable magnetic frame. Put this frame on the oven.
If you wish to remove the frame, use a thin object (e.g. screwdriver, knife etc.).
Proceed very carefully as this object may cause you injury or damage to the oven.
Notes:
– If the MW oven does not work properly, unplug it from the el. outlet, wait for 10 seconds
and then connect it again.
Ventilation (pic. 1)
Proper ventilation is necessary for cooling of the MW. If the ventilation openings are
covered during the operation of the MW, the MW will overheat. In such case, a heat fuse
will turn the MW off. The MW oven will not work unless it has cooled down sufficiently. Air
coming from the ventilation openings may heat up during operation. This is normal. Steam
is a normal product of cooking. The MW is designed in order that this steam is released
through ventilation openings on the side and in the back of the appliance.
VIII. INSTRUCTIONS FOR USE OF THE MW OVEN
SCHEMATIC DIAGRAM AND DESCRIPTION OF THE APPLIANCE (pic. 2)
A - ventilation openings
B - door
C - door sealing
D - opening door button
E - door latches
F - safety locks openings