Directed Electronics BOA 165B - Manual (Page 38)

35 © 2 0 0 4 D i r e c t e d E l e c t r o n i c s , I n c .
Has the tach wire been learned? See the Tach Learning
section of this guide.
Is the tach wire receiving the correct information? Either the
wrong tach wire has been used, or a bad connection exists.
➤ T Th hee cclliim maattee ccoon nttrrooll ssyysstteem m d dooeess n noott w woorrkk w wh hiillee tth hee u un niitt iiss
oop peerraattiin ngg tth hee vveeh hiiccllee..
Either the wrong accessory wire is being energized or more
than one ignition or accessory wire must be energized in
order to operate the climate control system.
➤ T Th hee rreem moottee ssttaarrtt w wiillll n noott aaccttiivvaattee..
Check harnesses and connections. Make sure the harnesses
are fully plugged into the remote start module. Make sure
there are good connections to the vehicle wiring.
Check voltage and fuses. Use a meter and check for voltage
between the RED wire and the BLACK ground wire. If you
have less than battery voltage, check both 30A fuses on the
main power wires. Also make sure that the ground wire is
going to a good paint-free chassis ground.
➤ T Th hee rreem moottee ssttaarrtt w wiillll aaccttiivvaattee b bu utt tth hee ssttaarrtteerr n neevveerr een nggaaggeess..
1. Check for voltage on the purple starter wire two seconds
after the remote start becomes active. If there is voltage
present, skip to Step 4. If there is no voltage present,
advance to Step 2.
2. Check the 30A fuses.
3. Make sure the purple starter wire is connected on the