Directed Electronics BOA 165B User Manual

Page 27

dealer. The majority of transponder-based immobilizer systems

can be bypassed using the 555U/556U immobilizer bypass

module available at your local retail dealer.

This BLUE wire (H1/1) of the primary harness supplies a

200mA output as soon as the control module begins the remote

start process. This wire can be used to activate an immobilizer

bypass unit.

To determine what bypass module your vehicle requires, check

your web vehicle information sheet.

step 9

The system comes with one transmitter. The receiver can store

up to 2 different transmitter codes in memory. Use the following

to learn the transmitter or to add a transmitter to the system.

The following is the basic sequence of steps to remember whenever

programming this unit:

1. K

Keeyy.. Turn the ignition to the ON position.

note: The system can only learn, after
being connected and with the FIRST
IGNITION ON. If not learned with
the first ignition on the battery will
have to be disconnected and then
reconnected and the procedure
repeated.

note: If power is lost to the control module (battery dis-
connected), the transmitters must be relearned.

➜