Directed Electronics BOA 165B User Manual

Page 16

Once the constant power wire (or wires) has been identified, solder

the two thick RED wires from the control module to it and cover

the connection with electrical tape to ensure a safe connection.

With the black lead still in the kick panel, locate the ignition

wire harness in the same location. It will test differently than

constant (+)12 volts. Locate the suspected wire using the

www.boasecurity.com web site and then use the LED tester to

probe the suspected wire. With the key in the off position the

LED tester will not illuminate. Turn the key to the on position

and the LED tester will illuminate. Now while watching the

LED tester, turn the key to the crank position and the LED

tester should not extinguish. If the LED tester extinguishes this

is not an ignition wire but an accessory wire. If the wire tests

correctly, solder the PINK (C) relay wire to it and cover the

connection with electrical tape.

warning! Before making any connection
to constant battery power make sure that
the two green 30 amp fuses are removed
from the fuse holders on the two thick red
wires. Failure to do so may cause fire or
shorting of sensitive electrical components.